 Click on  and Project
Open Engineering4 Wheel DriveWheel Section
Create the wheel points
 Draw a point  at  30
Draw a point at 20
Draw a point at 16
Draw a point at 6
Copy and rotate the wheel points
Select all 4 points (hold SHIFT key and click on each point)
Select Cursor as the action
Click on point 0 to move the cursor to the origin (point 0 = 0
 0  0 )
Select Rotate as the action
Copy (hold CONTROL key) and rotate the points using  10 degrees
Repeat the copy and rotate using by 10 degrees each up to 90 degrees as illustrated
Draw the lines
Press Draw as the action
Press Lines to work on lines
Draw the lines as illustrated
Fit, Rotate and Select
Press Fit to re-center the model on the screen
Press View Rotate as the action
Rotate the view as illustrated
Press Pick as the action
Press Lines to work on lines
Hold the SHIFT key and click on the two biggest lines to select them both (they should change to yellow)
Copy the lines
Press Move as the action
Copy (hold CONTROL key) and move the lines
up to 15
Select lines
Select the lines as illustrated
Move lines
Move the lines
up to 13
Select and Copy
Select the line located at point 3
Copy (hold CONTROL key) and move the line
down to 2
Draw triangles
Press Draw as the action
Press Triangles to draw triangles
Draw the triangles as illustrated
Draw triangles
Rotate the view as illustrated
Draw the triangles as illustrated
Draw triangles
Rotate the view as illustrated
Draw the triangles as illustrated
Draw triangles
Rotate the view as illustrated
Draw the triangles as illustrated
Create a new point
Press Points to work on points
Create a new point at 0
0 13
Draw triangles
Draw the triangles as illustrated
Press Save to save the model
(click here to go back)
| 
